
For dynamic measurement of effective and differential pressures
Pressure transducers based on the dynamic pressure measurement principle, for air flow meters of the VMR or VME series
The actual air flow value is presented as a linear electrical signal: 0 – 10 V DC. or 2 – 10 V DC DC.
Transfer of measured values for further display or transfer to slave controllers
Can be installed in any position
Parameters are set at the factory
Application
Universal Series Electronic Air Flow Controller with Built-in Dynamic Differential Pressure Transmitter for Air Flow Meters
Parameters are set at the factory
No additional configuration required at installation site
For standard air filtration requirements in air conditioning systems, the controller can be used for supply air without additional means of protection against contamination. Since the air flow partially passes through the sensor to measure the flow volume, please note the following:
When indoor air is contaminated with heavy dust, appropriate exhaust air filters must be used.
If the air is contaminated with lint or sticky particles or if it contains corrosive media, dynamic pressure controllers cannot be used
In this application, the Universal controller is used only to measure the differential pressure and to convert the measured value into a linear electrical signal. The inputs for connecting the desired value signal and the servo drive are not activated and do not correspond to the standard technical parameters.
The actual air flow value is output via a linear electrical signal